(0) Cart
  • No products in the cart.

LATEST MODS

BlogHome »

Carrying Case for Micro Helicopters

I took this photo to share on RCGroups. I figured I’ll post here as well.

RCGroups forum member Heli Pad gifted me this Harbor Freight Tools case and I configured it to hold 5 micro heli.

From top to bottom:

  1. Blade mCP X with extended tail boom
  2. WL Toys v911 (HobbyKing FP100)
  3. Blade mSR
  4. modded 9958MSR
  5. Xieda 9958 (HobbyKing HK-190)

Perfectly fits five micro helicopter and full size transmitter.

All those brands and model of helicopter are flown with the Turnigy 9x modded for DSM2 capabilities.

Behind the foam on top are pockets for the tools and extra parts. You can see how those pockets looks like over at Harbor Freight’s site.

I pulled out a block of foam, keeping them intact. Then cut a 1/4 off the bottom and reinserted back into place. It makes a nice little recessed compartment for my 1s LiPo battery.

1S LiPo compartment recessed.

Can anyone guess what this little momentary switch is for?

Little pressure switch hot glued into place.

If you guess that the switch is connected to the LED light strip at the top, you’d be correct. It gets toggled when the case is close, turning off the LED. We usually fly at the local park after my kids are put down for bed, so the light strip is great. I rigged up a 3S LiPo to power the LED light strip. The strip of LED was like $5 bucks at Hobby King, and has adhesive on one side. You cut it to the length you need. Then I used a 3S 2200mAh LiPo to power the LED because that’s what I had handy. You can probably go with something less. However, I intend on putting in a charger that will pull power from the same LiPo in the future. So that 2200mAh LiPo should work out pretty well.

Strip of white LED lights hooked up to a 3S 2000mAh LiPo.

Here’s the configuration…

And a charger powered off the same 3S LiPo pack that powers the LED

12 Comments on Carrying Case for Micro Helicopters