In almost all aspect of life, having the right tool makes the job much easier. When flying micro helicopters and quads, everything has to be micro sized in order to avoid adding unneeded weight that may robs the motor of it’s performance.
For wires, magnet wires, also known as enamel wires, are a must have in your tool kit. The bigger brand names such as Horizon Hobby with their Blade lineup of heli, uses magnet wires for their antennas and for the tail motor. Nine Eagles is another manufacturer that uses magnet wires to extend to the tail motor.
I find that a good gauge for these wires are about 30-32 AWG, measuring about 0.0085in or 0.02mm. You can find magnet wires if you search for them online. Locally, my Fry’s Electronics and Radio Shack have them in spools that will last you a long time.
Alternatively, you can find the right gauge magnet wire in small motors often used in toys. Also, fans used in computers is often another source, though I find they can sometimes be thinner than 32ga.
Simply take apart the motor and unravel the wire. Taking care not to rub against the rough armature and accidentally nick the enamel coating of the wire. One motor yields a lot of wire. After taking them off, you’ll see they are wavy and kinked.
A trick I use is to simply hold a section of the wire between each hand and running them back and forth against the edge of a a cutting mat, metal rod, or any edge that will not nick the wires and will not get damage if the wire start to cut into it. This trick will quickly straighten out the wire with a couple of passes. See the photos below…
To solder these magnet wires, you have to remove the enamel that coats the copper of the wire. The enamel is to prevent the wires from shorting out while wound up in the motor. Some people may scrape the thin enamel coating off. The trick I learned is that the enamel coating can be quickly burned off and the wire tinned at the same time using solder.
I put a blob of solder on the tip of my iron and touch the end of the magnet wire to it.
It takes but a second and you get a perfectly tinned tip, ready to be solder. Easy peasy. :)
Another tip for you. If you want to lower the overall resistance and thicken up the gauge of the wires, you can twist a few strands of the magnet wires together. I do this by putting one end into the power drill and hold the opposite end. The hand held power drill will make a perfect twisted bundle of magnet wire.
Here, you can see that three 32ga magnet wire twisted together has more copper than the original stock wires that feeds through the v929 boom. Because each wire has the enamel coating, despite having more overall copper, the twisted bundle is equal to the thickness of the original wires with it’s insulation. Which means you can still feed a positive and negative pair through the carbon fiber boom.
I like to use the magnet wire because it’s cheap, lightweight and it’s coating looks like anodized metal.
One final trick, for aesthetics, I will use the same color for positive and negative. To keep track of the polarity, I simply mark the each ends of the negative wire with a black sharpie so I properly solder it to the negative terminal. Twisted togther, they looks like an performance “upgrade.” :D The cooler looking it is…the faster it goes. ;)
That’s all there is to it. Hopefully this post helps you guys. Happy modding!!!