(0) Cart
  • No products in the cart.

LATEST MODS

BlogHome »

My 1S Charging Station

Just wanted to share my new 1S LiPo charging station. I took a 1s Micro parallel charging paraboard from Hobby King and mod it to become a serial charging board. I think this paraboard would be cheaper and easier to mod. Plus, it does not have the LED that drains the first lipo cell if you don’t remove the lipo right after charging has completed.

With this mod, I can use the balance port of the charger to individually charge each cell. I can charge from 1 cell to 6 cells.

1S_serial_balance_charging_para_board_mod_hack

 

Here’s a closer look.1S_serial_balance_charging_para_board_mod_hack_closeup

Here it is, charging two 150mAh LiPo. The stick the temperature probe near the cells so the iCharger could monitor the temp and be able to shut down the charging if any cell rises to unsafe temperature.1S_serial_balance_charging_para_board_mod_temp_sensor

And here’s how you configure the board if you were to charge 3 lipo cells. You simply move the positive lead to the last cell. I like it because I can charge all the various connectors normally used with 1s LiPo.

1S_serial_balance_charging_para_board_mod

You can also charge different capacity LiPo together. But for safety, you would limit yourself to the charge rate of the lowest capacity connected lipo. Not a big deal if you have the time. Otherwise, it would be better to charge cell combination with similar capacities.

Hope that inspires you with your own mods.

Categories: Mods
10 Comments on My 1S Charging Station