(0) Cart
  • No products in the cart.

LATEST MODS

BlogHome »

HiSky HCP100S BLHeli Brushless ESC

Pivotal moment for those of us who loves the opensource BLHeli brushless firmware from Steffen. HiSky’s new HCP100S double brushless micro CP helicopter comes with BLHeli firmware already flashed onboard. Not only that, the programming pads are big and accessible.

BLHeli toolstick connection points…
HCP100S_ESC_BLHeli_Flashing_Points

Main ESC was flashed with BLHeli 12.1. Governor modes are disabled. But Programming by TX is left enabled. Therefore, you should be able to use your transmitter sticks to enable/disable some of the features. Read the BLHeli manual under section for Beeps – Entering programming mode. The manual can be founded in the /manual folder after you download and unzip the BLHeli Suite software

(Another good read… DoubleCH explaination of governor modes)

The best method for updating BLHeli settings and flashing new firmware is by using a SilLabs based flashing stick in combination with the BLHeliSuite software you see below:

HCP100S_MAIN

Here’s the pinout for that flashing stick from BangGood listed above.

Tail ESC was flashed with BLHeli version 10.4

HCP100S_TAIL

And for you HCP100, v922, FBL100 and even mCPX owners. Here’s how it can look like if you repurpose the HCP100S dual brushless ESC for your heli…
HiSky_dual_brushless_ESC_on_HCP100_3in1_mCPX_conversion

HiSky_HCP100S_ESC_weight_BLHeli_support

8 Comments on HiSky HCP100S BLHeli Brushless ESC